Did you bleed the master before you started bleeding the slave? You need to do
this.
Gordon Glasgow
Renton, WA
> -----Original Message-----
> From: owner-datsun-roadsters@autox.team.net
> [mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of bill
> Sent: Sunday, January 05, 2003 2:00 PM
> To: Datsun-Roadsters List
> Subject: clutch master cylinder x-mac-creator="4D4F5353"
>
>
> I am trying to replace the clutch master cylinder. I can't seem to get
> all the air out of the line. the new cylinder is pumping fluid and when
> I open the bleeder at the slave, air and some fluid spits out. I close
> the valve before the clutch is released. When I reopen the bleeder I
> can hear the air getting sucked back into the system. After only a
> couple pumps it seems like as much air is getting sucked back in as is
> getting forced out and I can't seem to make any progress.
>
> What am I doing wrong?
>
> Bill
> 70 1600
> San Diego
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|