| To: | <BillDentin@aol.com> |
|---|---|
| Subject: | Re: Figure 8's |
| From: | "Mordy Dunst" <gasket.works@gte.net> |
| Date: | Sat, 11 Mar 2000 06:49:46 -0600 |
I can make figure 8 gaskets out of SS or Cu from .003" to 4.00" - What I don't understand is the reason for the "fig of *8" design? I don't think it is usefull.. In my motor I just made single gaskets for each cyl..... mordy |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Morgan, Paul Richardson |
|---|---|
| Next by Date: | Re: Gang aft agley, Irv Korey |
| Previous by Thread: | Saga of woe - non Triumph, longish, John Macartney |
| Next by Thread: | Re: Figure 8's, BillDentin |
| Indexes: | [Date] [Thread] [Top] [All Lists] |