RE: Tourque specs for wishbone to Trunion

["Randall Young" <ryoung@navcomtech.com>]

> List I purchased new trunions from TRF and they came with Nylock nuts and
> are not drilled for the cotter pin. Does anyone know what to tourque them
> to? The manual I have says to tighten them till they feel solid and then
> back the nuts off till the cotter pin hole lines up with the opening in t=
> he
> castled nut.

They should say to back off 1-1/2 to 2 flats.  The backing off part is
important, as this sets the clearance for the thrust bearings.

Randall