fot
[Top] [All Lists]

Error in the article: Repairing or Creating Chrome Stems on

To: Triumph List <triumphs@autox.team.net>,
Subject: Error in the article: Repairing or Creating Chrome Stems on
From: J M Wagner <jmwagner@greenheart.com>
Date: Wed, 26 May 2004 10:22:59 -0700
Don caught a snafu in my article, please make a note of it if you 
downloaded the article.  I meant circumference, but sometimes the brain 
and the hands don't cooperate.   --Justin

-------- Original Message --------
Subject:        Switch article
Date:   Wed, 26 May 2004 10:55:16 -0600
From:   don spence <dspence@oanet.com>
To:     jmwagner@greenheart.com


Hi Justin
Not meaning to be picky but I think you mean "circumference" not 
"diameter" in the passage quoted below. Circumference being the 
measurement of the edge or ring of a circle, diameter being the measure 
of a line drawn from edge to edge across the centre point.
Cheers
Don

unravel it to measure the diameter. You will want to cut the foil at the 
exact length, but with a little more width (diameter) to allow the foil 
to overlap at the seam. I went for > wide, and this turned out to 
provide much more overlap than I would have liked. You might go for a 
little less, but check your switch, the diameter could be different. 
Just shoot for about a 1/16 overlap.

<Prev in Thread] Current Thread [Next in Thread>
  • Error in the article: Repairing or Creating Chrome Stems on, J M Wagner <=