fot
[Top] [All Lists]

RE: [FOT] Manifold Gasket

To: <fot@autox.team.net>
Subject: RE: [FOT] Manifold Gasket
From: Bill Babcock <BillB@bnj.com>
Date: Thu, 16 Mar 2006 01:08:12 -0800
 No, but if you have had the head milled be sure to alter the gasket to fit.
Generally you can just press the gasket in place and see if you need to trim
any material off the lower edge. I press the gasket in to create a line
where the head meets the cylinder and then use good scissors (carefully
avoiding my wife's attention) to trim the gasket. 



<Prev in Thread] Current Thread [Next in Thread>