[Top] [All Lists]

Re: [FOT] trans top conversion

To: "Jack W. Drews" <>
Subject: Re: [FOT] trans top conversion
From: Larry Young <>
Date: Mon, 06 Nov 2006 17:49:11 -0600
I've done it and our transmission article at explains what you 
need ( ).  You 
need a 16mm x 2mm tap and 35/64 drill. I can loan you mine if you need.

Jack W. Drews wrote:

> Has anyone converted a standard transmission top to make it into an 
> overdrive transmission top? It just takes two threaded holes, but the 
> threads are not standard USA sizes.
> If you did it, what kind of tap did you use?
> thanks
> uncle jack
> ------------------------------------------------
> No Virus Found In This Message
> Scanned at
> ===  Help keep Team.Net on the air
> ===

<Prev in Thread] Current Thread [Next in Thread>