ARP can also supply head studs. I like the ones that are a little
longer for the short corner bolts that often develop cracks in the
block. You can drill and tap a couple more threads if you get a proper
bottoming tap.
On Jul 8, 2008, at 5:49 PM, Tim Murphy wrote:
> Forgot to ask in the last post about stock TR4 conn rod bolts. I
> have one
> "bad" one (goes in tight, either stretched or dinged threads that I
> can't
> see). Moss has bolts that apparently are made of the "unobtainium"
> that Mark
> Donohue said Penske was using in the Can-Am cars back in the day
> because they
> are $17 each. Checked the ARP web site, didn't see anything but
> haven't tried
> calling yet. Can also call and ask about the washers.
>
> Forgot to mention that I did look in McMaster Carr and MRC for the
> washers but
> they didn't have the hardened and ground. Sorry about that. I
> don't think
> the Gr. 8 washers are case hardened, not positive however.
> Thanks again,
>
> Tim
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
Bill Babcock
Babcock & Jenkins
Billb@bnj.com
503.936.7660
www.bnj.com
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|