so, here's a copy of a thread from a while back, written by John Styduher and
Tony Drews. You can buy the parts Southwick used, cut the axle housing, and
have someone weld on the bearing retainers, and for a lot less money and
shipping costs.
> My "copycat" Southwick conversion on a TR3 rear axle uses the 9" small Ford
> housing ends (the housing ID for the sealed bearing is 2.835"). The last
> step on the housing end is removed and then fit perfectly over the axle
> tube (2.25"OD) for welding. The Ford axle housing fits right up against
> the small locating tab which located the outer leaf spring u-bolt, so
> orientation for track width is easy. Moser engineering sells the 24-spline
> axles for $370.00, bearings and wedding band retainers installed for
> $75.00, and they can drill the stud holes on a 4x4.5 pattern for whatever
> wheel stud knurl diameter you are using. Make sure to have them drill an
> access hole in the flange to make it easy to install and remove the axle
> without taking the brakes apart. Same setup for TR4 but longer axles as
> you TR4 guys and gals already know. Like Tony mentioned, the brake backing
> plates will need to be modified for the 4-bolt bearing retainer (backing
> plate ID needs to be enlarged slightly to slip over the bearing and the 4
> mounting holes for the C-shaped retainer need to be drilled). As another
> patron mentioned, you can mock everything up and do your welding in situ.
> While your welding, go ahead and weld the axle tubes to the pumpkin for
> stiffening.
>
>
> On Sun, Jan 19, 2014 at 8:54 PM, Tony Drews <tony@tonydrews.com> wrote:
>
>> The stock design solid axle will flex in the tapered portion where the hub
>> is pressed on. The car I rolled had stock design axles but made out of
>> very good steel and stock design hubs also made out of very good steel.
>> They were manufactured so that the "stress risers" were removed, but under
>> load the axle, about 1/3 of the way inboard of the outer nut, starts to
>> flex. You can see the fretting inside the hub where that happens. It
>> bends over and over until it breaks.
>>
>> The "Southwick Rear Axle Conversion" uses Ford 8" axles that are cut down
>> in length and re-splined for the TR-differential. The outer end of the
>> axle tube is cut off and the outboard end of a Ford 8" axle tube is welded
>> on. It is possible that someone sells just that outer end of the axle
>> tube. The backing plates are machined in the center to have a larger
>> diameter hole and holes are drilled for the 4 bolts which hold the axle
>> bearing into the housing.
>>
>> These axles are a one piece design - the hub / flange is part of the axle
>> shaft. The outer bearing is pressed on and an inner retainer is pressed on
>> to hold the bearing in place. It is a sealed bearing, so acts as the
>> bearing AND the outer seal. There is an o-ring which goes around the
>> outside of the bearing to seal that area too.
>
On Jul 10, 2014, at 5:46 PM, toodamnfunky@comcast.net wrote:
FoT,
I know someone preparing a live axle TR4 to go racing next year and since
Southwick closed he doesn't know what to do for axles. Are Ford axles the
answer ? I read somewhere the TR4A live axle is stronger, true ?
Jim g
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|