At 07:40 PM 4/15/02, Gary Browning wrote:
>But the map was not what I expected. I had expected a pattern of an upside
>down 'T' like the pattern I had moved the G-Cube through. What I got was a
>line that started at the bottom and went vertically up. There were no left or
>right, just vertical !! The L/R strip chart shows 0.2G left at one point,
>but map shows no left movement. It does show vertical movement though.
Gary,
I'm not clear on what you actually did but you might try this:
Use your normal settings including autostart.
Tip cube first on say the back side (simulates a start), then the left
side, then the right side, then the front. (just like during calibration)
Repeat a few times just to be sure you have started the recording and keep
it going long enough to get a minimum run.
When the cube is actually on a side, front, or back the G reading should be
1 (if I recall) in the relevant direction. The lateral g's would alternate
between 1 g left, zero, and 1 g right. Accel would alternate between 1 g
accel, zero, and 1 g braking. Basically lots of "steps" if you are smooth
but relatively quick with the changes.
It has "been awhile" so I don't guarantee that this is correct:-)
Dick Rasmussen
CM 85
85 Van Diemen RF-85 Formula Ford
/// Archives at http://www.team.net/archive
/// Check http://www.team.net/mailman/listinfo for other lists of interest.
|