Bill,
If you use screws through the pans and into the body from the cockpit side,
the pans are a whole lot easier to remove, if desired, to gain access to the
fuel pump, differential, etc. Just my personal opinion.
Bob
BJ7
----- Original Message -----
From: <INSPTWO@msn.com>
To: "healey help" <healeys@autox.team.net>
Sent: Monday, June 07, 2004 6:55 PM
Subject: rear seats
> The only rear seat pans I could get for my BJ7 were the seat pans for the
> BJ8.
> The BJ8 pans come with bolts already attached and, suprise, the holes
don't
> match up to the frame holes already in the car. Looking for points of
view.
> Cut off the bolts and drill new holes in the pans for the attachment
scrrews
> or try to allign the new pan bolts and drill holes in the body.
> Bill
> BJ7
|