Bill,
Assuming that you have the correct cross section trunk seal, if you look at
the cross section you will note that one side is fairly perpendicular to the
back surface. This tucks into the corner flange of the lid, leaving the more
angled surface to go toward the centre of the lid.
Rich Chrysler
----- Original Message -----
From: <INSPTWO@msn.com>
To: "healey help" <healeys@autox.team.net>
Sent: Tuesday, June 29, 2004 10:02 AM
> I need help in installing the trunk gasket. There is a thin edge and a fat
> edge on the gasket. On installing it, does the thin (or sharper edge) face
the
> trunk and the fatter edge face away from the trunk or is it the opposite?
> Thanks,
> Bill
> BJ7
|