A BJ8 restoration is making slow but solid progress.
Help would be appreciated on a couple of items:
1. My car has an Allison Automotive [Covina, CA]
solid state ignition module, [about 2x3 inches] and
the associated optical trigger in the distributor.
Does anyone have experience with this device - good or
bad, and does anyone have a circuit diagram that came
with the device. AS far as I remember before the tear
down it was working, but I now need to decide on its
2. My carb heat shield has lost all the padding
material that was originally attached on the
underside. The shield is fine and I would rather keep
the original. I would like to attach an equivalent
material to the underside. Has anyone found a source
of suitable material - presumably without asbestos.
Does Home Depot have something in sheet for that would
hold up to the heat, dirt and time?
Robert, 65BJ8, CA
Robert - 65BJ8
If this email message has been received by you in error, please contact the
sender asap - Thank You.
Yahoo! Mail - Helps protect you from nasty viruses.
Check out the new British Cars Forum: