I'm measuring the Toe-in on my '56 BN-2. It is driving real nice but I just
wanted to make sure the toe-in was set within range.
I'm using a laser level that I purchased for 10$ and a 2X4. Just for kicks!
I'm getting a measurement of about 0.4 degrees and I think that corresponds
to around 0.09 inches toe-in.
My question is in regards to how the toe in is measured.
I guess it may seem obvious to some but, is it the distance that the forward
edge of the tire turns in relative to the center of the tire? I know that
some people measure the rear edge and compare that to the front edge but
then do they divide by two?
My laser level technique is kinda cool, if anybody is interested I can put
the procedure up on my website www.RickNeves.com
Sincerely
Rick Neves
'56 BN-2
_._
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.296 / Virus Database: 265.5.4 - Release Date: 12/15/2004
|