I have the same question as Gordy, any insights? This is where where
the harness should travel as it goes from the flasher relay to the LF
headlamp. I can't tell the place it transitions from the engine bay
to the under fender/behind grill areas.
My original harness was too chopped up and spliced to tell what it
should have been. And this is on my too do list for today.
Thanks
Patton
On 5/21/05, ggilliam@usol.com <ggilliam@usol.com> wrote:
> Experts,
> I received a picture of the basic harness on the front of the
> chassis; the picture is good, but it doesn't show what I need. I
> don't know what to do with the lengths of wire beyond the clips
> you see on the front of the bulkhead that then run to the lights...
> do they go up over, under or around the "mud flap" ahead of the
> tire, or clip to something, somewhere....or what?
>
> Thanks again for your assistance through this whole long
> rebuilding process, the end is in sight....but probably with a few
> more hurtles in the track before the finish line...but are these
> projects ever really done?
>
> Gordy
--
Patton Dickson - Richmond, TX
'57 A-H 100-Six - http://Austin-Healeys.com
|