Hello James,
The internal splines in the overdrive are out of phase.
To rectify this you have to line them up with a long probe inside the
overdrive.
Afterwards remember that you can only rotate the rear drive flange in a
anti-clockwise rotation, the other way you will loose the phasing once more.
Don't forget to hold the pump plunger down as far as it will go with the
drawire too, until you have almost bolted completely up then remove, [ this
locates the pump operating plunger over the operating cam on the
mainshaft ].
Hope this information helps.
Regards.
David.
Original Message -----
From: "James Shope" <healeymanjim@JoiMail.com>
To: "healeys" <healeys@autox.team.net>
Sent: Tuesday, May 02, 2006 4:55 AM
Subject: trans question
>i bought a side shift transmission from a lister, which has a tag that says
> bn7 on the top. the old side shifter i took out had a tag that said bn4
> on
> the top. laboring under the assumption that most of the early overdrives
> were
> similar, i tried to mate up the bn7 trans to the od i took off the bn4.
> it
> slides in until there is about1/4 to 3/8ths inch left then will no go any
> further. i am not about to try to force it. do i have the wrong od for
> this
> trans or have i done something else wrong. any help will be appreciated.
> thanks in advance. healeymanjim
|