Hi, Allen -
The beading for the front fenders is kinda straight, but there is a separate
beading for the rear fender (Moss P/N 021-820) that doesn't need to be bent
to fit the fenders. Are you sure you have the right part?
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA
-----Original Message-----
From: owner-healeys@autox.team.net
[mailto:owner-healeys@autox.team.net]On Behalf Of Allen C Miller, Jr.
Sent: Sunday, October 01, 2006 6:21 AM
To: healeys@autox.team.net
Subject: rear fender beads
The body shop painting 'Emily' is concerned about bending the straight
fender
beading I got from Moss around the tight radii of the rear fenders. Do you
do
this in place by pulling the tabs one-by-one, or is it done off the car with
some kind of bending tool(s). Clueless about this.
Thanks
Allen Miller
|