Could be trans mount.
-----Original Message-----
From: healeys-bounces+wsthompson=thicko.com@autox.team.net
[mailto:healeys-bounces+wsthompson=thicko.com@autox.team.net] On Behalf Of
Tom Felts
Sent: Sunday, September 23, 2007 5:55 PM
To: pdeturck@rochester.rr.com; Healeys@autox.team.net
Subject: Re: [Healeys] noise when braking
Well---maybe I should have read your whole post b/4 replying. If not the
splines, then ????.
tom
> [Original Message]
> From: <pdeturck@rochester.rr.com>
> To: <Healeys@autox.team.net>
> Date: 9/23/2007 12:33:35 PM
> Subject: [Healeys] noise when braking
>
> My '66 BJ8 has developed a "clunk" whenever
> I step on the brake. It is barely audible at most
> forward speeds but is easily noticeable when
> going in reverse. It only occurs once when the
> brake is applied and is only at the right front.
>
> I have inspected the hub and spoked wheel
> and the splines look good. A mark on the wheel
> and knockoff show no additional rotation after
> tightening.
>
> Suggestions on where to start looking next?
>
> Disk brakes? Front wheel bearings (though
> there is no perceptible play when raised off
> the ground)?
> -pd-
> 66 BJ8
> _______________________________________________
> tomfelts@earthlink.net
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
wsthompson@thicko.com
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|