Kurt,
You can remove the tank and drill down thought the angled fitting (I
filled my tank with water before doing this). Then you can push a
coat hanger or other stiff wire through the hole and punch out the
wire filter. To patch it, tap the hole (1/4:20 worked for me) to
accept a brass machine screw. Then you can solder that in place and
file it flat. It is hardly noticeable when competed. I would
recommend that you place a fuel filter in between the tank and gas
pump should you go this route.
John
Been there ...
At 11:51 AM 10/9/2007 -0400, Michael Salter wrote:
>Hi Kurt,
>..... Sorry, I can't recommend a solution other than a new tank!!
>
>Michael Salter
>
>-----Original Message-----
>From: healeys-bounces+msalter=precisionsportscar.com@autox.team.net
>[mailto:healeys-bounces+msalter=precisionsportscar.com@autox.team.net]
>On Behalf Of Kurt Leslie
>Sent: October 9, 2007 11:38 AM
>To: healeys@autox.team.net
>Subject: [Healeys] 62bt7
>
>..... Is there a fuel screen inside the tank? Or is the tank not
>properly vented? Kurt
>_______________________________________________
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|