healeys
[Top] [All Lists]

Re: [Healeys] BJ8 console trim

To: <healeys@autox.team.net>
Subject: Re: [Healeys] BJ8 console trim
From: "sbyers" <sbyers@ec.rr.com>
Date: Fri, 22 Feb 2008 17:46:31 -0800
Gary, I used small stainless steel screws and ground down the heads to fit
the channel.

Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC  USA

-----Original Message-----
From: healeys-bounces+sbyers=ec.rr.com@autox.team.net
[mailto:healeys-bounces+sbyers=ec.rr.com@autox.team.net] On Behalf Of
Warthodson@aol.com
Sent: Friday, February 22, 2008 4:40 PM
To: healeys@autox.team.net
Subject: [Healeys] BJ8 console trim

I have to replace two of the "T" head screws that hold the stainless (or  
chrome) trims strips that run along the sides of the BJ8 center console. The
"T"  
end slides into the bottom of the trim strips & the screw portion holds the

trim against the console. I could just leave two of these off but would  
prefer to replace them. Does anyone have a source for these or a suggestion
on  how 
you have made replacements?
Thanks,
Gary Hodson
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>