healeys
[Top] [All Lists]

Re: [Healeys] Number plate

To: "Bob Abbott" <thehealeyguy@gmail.com>, <healeys@autox.team.net>
Subject: Re: [Healeys] Number plate
From: "Rich C" <richchrysler@quickclic.net>
Date: Mon, 14 Apr 2008 21:40:56 -0400
Hello all,

This rings a bell however that I believe the BMIHT data may record gearbox 
and rear axle numbers though they don't bother to record them on a Heritage 
Cerificate. If that is all that one has left to work with, they may be able 
to do a search by these numbers to get the chassis numbers, etc, that you 
need.

Rich Chrysler

----- Original Message ----- 
From: "Jim Culp" <jculpjr@yahoo.com>
To: "Jim Culp" <jculpjr@yahoo.com>; "Bob Abbott" <thehealeyguy@gmail.com>; 
<healeys@autox.team.net>
Cc: <david.r.altman@altmancompany.com>
Sent: Monday, April 14, 2008 9:23 PM
Subject: Re: [Healeys] Number plate


>I looked up the proper information on the chassis #'s for BT7's.
>
>>From the Anderson/Moment restoration guide (on 6 cyl roadsters):
>
> "A common reference number appears on various body panels, including the 
> splash panel, hood latch bracket, hood hinge bracket, and trunk lid prop 
> bracket.  Another number, probably a Boulton Paul frame number, was 
> stamped on the right-hand shock tower.  These numbers do not match either 
> the car number or body number on the six-cylinder cars.  the body number 
> was stamped on the backs of the cockpit moldings on the first series BN4's 
> but this practice apparently was discontinued with the BN6's.  Serial 
> numbers were stamped on the transmission, overdrive and rear axle, though 
> these did not match other numbers on the car."
>
>
> Jim Culp <jculpjr@yahoo.com> wrote: I believe the BJ8's have the chassis 
> number stamped on or near the passenger side front suspension area- maybe 
> BT7's have the same?.  Forgive me if I'm off base here- I just remember 
> reading somewhere that the chassis # was stamped somewhere else on the 
> car.
>
> Bob Abbott  wrote: Guys,
> I have a BN7  that's been in storage for years and I'm thinking its time 
> to
> take on the project. Trouble is the fire wall was cut out when the PO was
> planning to drop a V8 in it. So I have no serial #. The car did come with 
> an
> engine (Healey six) but not the original engine, so I can't even use the
> engine to try and find the car #.
> My question to the group is: what would be the best way to get a # plate 
> for
> this car so that I can get a title issued. Any suggestions would be
> appreciated
> Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>