Rich wrote"
The two forward tenax studs for the armrest are special in that they screw
into the gearbox cover carpet, and remain floating in the carpet, held there
with a base somewhat like the female tenax base with the screw on disc that
bites
into the material. The gearbox cover carpet in turn is snapped onto the
cover with ring type carpet snaps, holding it down securely and tight. Male
carpet snaps on the gearbox cover are fastened there with machine screws. "
New questions:
The screws holding the snaps to the floor are self tapping #6 screws.
Rich ,
1.) In regard to the snaps on the gearbox cover, Are there 4 of them, one at
each of the corners.
2.) Are there snaps on the Armacord that runs beneath the seats?
3.) does one cut holes in the jute so the snaps will secure to the floor? or
do the snap ring tangs go through both jute and carpet?
4.) Does the ffoward part of the Transmission tunnel with the flat lip
actually screw on to the firewall plate? and if so...how may screws does it
take?
Thanks _William BN1 with BN2 gearbox
_________________________________________________________________
Make i'm yours. Create a custom banner to support your cause.
http://im.live.com/Messenger/IM/Contribute/Default.aspx?source=TXT_TAGHM_MSN_
Make_IM_Yours
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|