Agreed. So long as you have the old post(?) you should be able to stick it
back and reinforce it slightly with whatever you call your equivalent of our
"Plastic Metal" (a two component epoxy metal).
Good luck!
If it all goes horribly wrong and you need to buy another badge, beware of
the repros that are around, over here at least.....enamel and detail is 100%
except for the hyphen between the "Austin" and the "Healey". Can't recall if
there should be one or not. Anyhow the MkII one I was offered was wrong.
Simon.
-----Original Message-----
From: healeys-bounces+simon.lachlan=homecall.co.uk@autox.team.net
[mailto:healeys-bounces+simon.lachlan=homecall.co.uk@autox.team.net] On
Behalf Of James Lea
Sent: 28 April 2008 14:57
To: Warthodson@aol.com; mayorrichard@hotmail.com; healeys@autox.team.net
Subject: Re: [Healeys] A-H badge repair
Richard. I had several break in the same place and successfully repaired
them with two component epoxy metal that you can find at any good hardware
store. Do not apply heat in any way as it will ruin the enamel on the front.
Good luck. JL
James Lea
PO Box 25
Rockport Maine 04856
1-207-236-3632
1951 Triumph Renown
1952 MG TD
1952 Triumph Mayflower
1958 Rover P4
1962 Austin Healey BT7
1966 MGB
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as simon.lachlan@homecall.co.uk
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|