Lou,
A group of us had some rear bumpers produced by a fellow in Ohio. They are
really quite excellent, but being hand made, and the fellow having personal
problems, they have taken an extremely long time to be made. There was an
initial order of around 20 pieces, and some of these may still not be
finished and delivered. This process has taken well over two years. I really
don't think he's willing to take on any more, nor would you want to wait
that long for them.
Any repros I have seen are not nearly as curved as they should be. These
should parallel the rear of the body as viewed straight down from above. If
they are too straight, it results in the number plate lamp almost touching
the body, and the gap between bumper and body being very uneven and
unsightly.
I really don't know what to recommend at this point.
Rich Chrysler
----- Original Message -----
From: "Lou G" <lgalper1@cox.net>
To: <healeys@autox.team.net>
Sent: Friday, August 22, 2008 2:42 AM
Subject: [Healeys] Hundred Rear Bumpers
> After the flurry of bumper chat several years ago, we haven't heard much.
> It's time again to replace my rear bumper.
> It is a bent reproduction.
>
> Has anyone suceeded in making the rear bumper correctly?
> Is there anything better than the AH Spares premium product?
> Is the M**s item the same thing?
>
> thanks,
> Lou
> BN1
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|