Dear Lennart
Regarding you second point. The line through the pinion shaft is not on
the centre line of the car. It is offset by about 1/2". Don't worry
about this, the propeller shaft can easily cope with this small
misalignment.
Regards
>After many years of idle I'm trying to do some work on my project 100. I
>did some measurement on the rear spring anchoring points. The width
>across the frame doesn't match the width across the rearaxle, also the
>differential doesn't seem to be centred on the rear axle. What is the
>correct width? Shall the differential be slightly off-centre? This is a BN1.
>
>Best Regards
>Lennart Nystedt
>Sweden
>BN156102
--
John Harper
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|