healeys
[Top] [All Lists]

Re: [Healeys] BJ8 Bell exhaust

To: "mailmaineguide.com" <info@atteanlodge.com>
Subject: Re: [Healeys] BJ8 Bell exhaust
From: Oudesluys <coudesluijs@chello.nl>
Date: Sun, 22 Mar 2009 17:54:42 +0100
Brad,
Although it may not be original I would certainly be practical andcreate 
some space between trunk floor and petrol tank by fitting a few rubber 
strips or blocks under the tank leaving a space of about 1/2" to let air 
circulate and dry out possible condensation which otherwise may rot out 
the tank and/or trunk floor. I have seen this happen lots of times with 
various cars.
mailmaineguide.com schreef:
> Hi List.....A couple of days ago I proudly and eagerly began installing my new
> Bell exhaust to the BJ8, there have been a few minor glitches that I have been
> able to overcome, not enough bolts of the correct length and too many of
> another etc. Now I am at the rear most hanger bracket and I am stumped, the
> service parts book indicates two bolts are to go through the bottom of the
> trunk floor and  are to hold the hanger in place although the book does not
> show those two bolts, after removing the gas tank and inserting the two bolts
> thru the holes that correspond with the holes in the bracket and re-inserting
> the gas tank I find the tank actually sits on the bolt heads which, needless
> to say is not an acceptable situation. Should I somehow shim the space between
> the tank and the floor, if so, any recommendations of what to use?? Per usual,
> many thanks for any info.
>
> Brad Holden
> Jackman, ME
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as coudesluijs@chello.nl
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>