Manifold->Gasket(*)->Insulator Block->Gasket->Heat Shield->Gasket->Carburettor
(*) Neither the parts book nor Moss catalog show this gasket, but I believe you
need one. I have them on my BJ8--it's a different material than the heat shield
gaskets (which appear to be paper)--and may come with the carb rebuild kits.
I can't imagine not putting a gasket between the insulator block and the
manifold--seems like you'd be asking for an intake leak (the insulator block is
a hard plastic, probably Bakelite).
Bob
mailmaineguide.com wrote:
> Gentlemen:
> It is time to put the rebuilt carbs on the BJ8 and I would like to know the
> gasket/heat shield sequence, I have researched the archives and there seems to
> be some discrepancy in the order of replacement, any advice would be mushily
> appreciated before I plunge headfirst!
> Brad Holden
> 67 BJ8
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|