healeys
[Top] [All Lists]

Re: [Healeys] Replacing pinion oil seal

To: Bob Spidell <bspidell@comcast.net>
Subject: Re: [Healeys] Replacing pinion oil seal
From: Oudesluys <coudesluijs@chello.nl>
Date: Wed, 06 May 2009 21:43:38 +0200
Could not see that on the exploded view. Does not matter, it does not 
play a role. It all makes less to disassemble.
Kees Oudesluijs


Bob Spidell schreef:
> The dust cover is a disk with a lip that fits over the yoke on the 
> outside of the housing; i.e. it's not pressed into the housing. 
>
> I called this 'flange' and 'yoke' in a previous post, it's actually 
> the yoke and the dust cover that slips over it.  They look like one 
> part and usually come off together.
>
>
> bs
>
>
>
> ----- Original Message -----
> From: "Oudesluys" <coudesluijs@chello.nl>
> To: "Mark Schneider" <mandmschneider@comcast.net>
> Cc: healeys@autox.team.net
> Sent: Wednesday, May 6, 2009 10:36:02 AM GMT -08:00 US/Canada Pacific
> Subject: Re: [Healeys] Replacing pinion oil seal
>
> To pull the pinion flange you probably do not need a puller, at the most
> than the usual two legged afair to help a bit. It should not be a
> pressed fit.
> The pressed end plate you are referring to is probably the metal dust
> cover that is pressed in over the seal it self. You can remove this dust
> cover and the seal using a large screw driver. You probably need to
> replace this cover as wel as the seal, as it is likely that it gets
> damaged in the proces. The BJ7/8 partnumber is ATC7101 for the cover and
> ATC 7085 for the seal.
> Kees Oudesluijs
>
>
>
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.325 / Virus Database: 270.12.19/2099 - Release Date: 05/05/09 
>13:07:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>