Did one of the Healeys have a 3/4" bore?
Rick
--- On Thu, 5/7/09, Rich C <richchrysler@quickclic.net> wrote:
From: Rich C <richchrysler@quickclic.net>
Subject: Re: [Healeys] BJ7 Brake M/C Bore Size?
To: healeyrick@yahoo.com, healeys@autox.team.net
Date: Thursday, May 7, 2009, 5:52 PM
Brake master cylinder bore for the standard non servo BJ7 is 5/8". It's
idential to the clutch master cylinder.
Rich Chrysler
----- Original Message -----
From: "HealeyRick" <healeyrick@yahoo.com>
To: <healeys@autox.team.net>
Sent: Thursday, May 07, 2009 5:30 PM
Subject: [Healeys] BJ7 Brake M/C Bore Size?
> Anyone know the bore size on the BJ7 brake master-cylinder?
>
> Thanks in advance,
> Rick
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|