healeys
[Top] [All Lists]

Re: [Healeys] Gearbox & Overdrive Hardware

To: Mark Schneider <mandmschneider@comcast.net>
Subject: Re: [Healeys] Gearbox & Overdrive Hardware
From: Oudesluys <coudesluijs@chello.nl>
Date: Tue, 07 Jul 2009 19:53:28 +0200
Did you use a torque wrench and did you apply the specified torque loads?
Kees Oudesluijs
NL


Mark Schneider schreef:
> Good morning list folk,
>
> I recently completed a total gearbox and overdrive tear down, parts 
> inspection and replacement as necessary, and reassembly.  After the 
> system was back in the car and had 600-700 miles on it I needed to 
> correct a major leak that had developed.  As a result of this second 
> effort I found nearly all of the nuts and bolts on the system casework 
> required re-tightening.  Having never before having tackled a project 
> like a transmission overhaul I was surprised to find the fasteners had 
> apparently loosened.  I had very carefully wrenched them all during 
> the reassembly process with the objective of making sure all nuts/lock 
> washers and bolts were as tight as they had been on disassembly.   Yet 
> they all took one to two flats of re-tightening during the leak 
> search.  Is this need to re-tighten transmission hardware at all 
> common?  Oh yeah, leak found and fixed.
>
> Mark 3
> '66 BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as coudesluijs@chello.nl
>
> http://www.team.net/archive
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.386 / Virus Database: 270.13.7/2222 - Release Date: 07/07/09 
>05:53:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>