Thanks for the feedback Rich. I have Clear-Flex blades that were on my
car when I bought it.
I may switch over the refill rubber from the Moss Taiwan units to the
Clear-flex.
Moss uses a rivet at each end to keep the refill from sliding out rather
than a clip arrangement. The long part of the rivet shows and not the flat
side. It looks ridiculous. The Moss arms seem to be very close to
original as you said and should work fine.
Thanks again, Mark
----- Original Message -----
From: "Rich C" <richchrysler@quickclic.net>
To: "Mark LaPierre" <lapierrem@sbcglobal.net>; <healeys@Autox.Team.Net>
Sent: Saturday, July 25, 2009 4:09 PM
Subject: Re: [Healeys] Wiper Blades and arms
> It's rather ironic that of the very few items I buy from Moss, their wiper
> arms for the roadsters are the ones of my choice because they are very
> accurate to the originals. The "hooked end" design works very well and
> their repro wiper blade refills are accurate, drop right in to the
> original Rainbow" blade assemblies and seem to work well clearing the
> glass too.
> That said, I've been using Rainex lately so the wipers only need to do the
> occasional pass over the glass.
>
> Rich Chrysler
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|