healeys
[Top] [All Lists]

Re: [Healeys] Spedo/Cable/Angle Drive - BJ8

To: healeys@autox.team.net
Subject: Re: [Healeys] Spedo/Cable/Angle Drive - BJ8
From: Peter Caldwell <peter@nosimport.com>
Date: Mon, 27 Jul 2009 10:52:42 -0700
Having rebuilt quite a few angle drives, it is never the gear that's 
at issue, it's the insert in the gear that retains the bit of cable 
that goes into the transmission.  The insert can slip, but more often 
the small section of cable breaks.  Usually caused by some tightness 
"upstream" toward the gauge.

Bouncing is often caused by the cable end going into the speedo being 
too long, and pushing the cone against the cup so that it touches 
every now and again.... the bounce. The jewel bearing will wear a bit 
as a result. At higher speeds, the counter spring is wound tight 
enough to over come the bouncing.

Try inserting a washer or 2 at the gauge end of the cable to space 
the inner cable out of the gauge a little farther. It should help the 
bouncing.  Spacing the angle drive similarly will help its life span as well.

Peter C.

=
At 08:09 AM 7/27/2009, Ron Ray wrote:
>Richard,
>
>My speedometer bounces at every speed even after being rebuilt by MOKAN
>twice.
>Hopefully someone on this list can help us both with this problem.
>
>Ron
>Can anyone suggest a solution/cause to the needle bouncing all over the
>place
>at about 50 mph but not at 70+ or less than 40? It does this often but
>sometimes it behaves. The speedo was rebuilt 8K ago. I think it always has
>done this. Seems to be accurate according the GPS.
>Rich (yea, another Richard) Kahn
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>