Doug,
Soak in warm distilled white vinegar, which is about 5 to 6 % acidity. This
will gently take take the rust off. You can clean with water just use WD-40
to displace any water and lubricate the inside when finished.
I've cleaned a similar switch using this technique.
Cheers,
Curt
On Tue, Sep 15, 2009 at 4:52 PM, dwflagg <dwflagg@juno.com> wrote:
> I have a Lucas push pull switch with surface rust on the case. Is there
> anything I can soak it in to remove the rust without damaging the switch.
> Also, the knob is not secured in place with the spring loaded button. It
> is on a slotted shaft, but I'm am not sure how to remove it. Any
> thoughts? Thanks.
>
> Doug
> ____________________________________________________________
> Best Weight Loss Program - Click Here!
>
>
>http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTFoYbGmbCfgYrczlNDbzneoISrMoK6Pwu9Xph0yoaIQxpmIkMF2Qw/
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as cnaarndt@gmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|