As I posted once before, be certain that the two loops are positioned a
safe distance away from the wiring harness.
I had those loops cut into the wires and ....my fire extinguisher was
needed!
GaryB
--------------------------------------------------
From: "Richard Dryman" <rdryman1@yahoo.com>
Sent: Thursday, October 08, 2009 6:09 PM
To: <Editorgary@aol.com>
Cc: <Healeys@autox.team.net>
Subject: Re: [Healeys] Temp Sensor Routing
> Why is no one mentioning the 2 brazed spring clips on the heater pipe
> mounts
> that clip & hold the water temp wire???
> My clips are original unless they
> were added within 2 years after the original owner bought the
> car{unlikely}.
> Guess they changed after 1965 production???
> Concur with the 2 loops at
> firewall.
>>>>>>
> http://picasaweb.google.com/rdryman/AusTinHeaLey#5369195717451367410
> ________________________________
> In a message dated 10/8/09 11:07:08 AM,
> healeys-request@autox.team.net
> writes:
>
>
>> I have a BJ8 (late 1967) right
> hand drive. I have seen a number of
>> different looks to the
> routing/appearance of the wire wound water temp
>> senor
>> cable in the engine
> bay. Should there be a coil in the engine bay >
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as gbrierton@hotmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|