healeys
[Top] [All Lists]

Re: [Healeys] Exhaust hanger in compression

To: "Steve B. Gerow" <steveg@abrazosdata.com>
Subject: Re: [Healeys] Exhaust hanger in compression
From: Oudesluys <coudesluijs@chello.nl>
Date: Mon, 23 Nov 2009 10:35:40 +0100
This is a far better construction than the rubber in tension. However if 
you move the bracketery to the rear edge of the floor pan, you can make 
the brackets simpler and with much more space to work on, L bracket to 
the vertical part, U bracket to the exhaust pipe with the rubber in 
between. You would also have more space for the exhaust pipe to move about.
Kees Oudesluijs
NL
>
> On Sun, Nov 22, 2009 at 12:19 PM, Steve B. Gerow 
><steveg@abrazosdata.com>wrote:
>
>   
>> Following up on some ideas expressed here, I redid my broken exhaust
>> hangers today. The rear one I changed to act in compression rather than
>> tension, in order to provide additional safety in the event of rubber
>> failure.
>>
>> Pic at: http://www.pbase.com/stevegerow/image/119598505
>>
>>
>> --
>> Steve Gerow
>> Pasadena, CA
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>