healeys
[Top] [All Lists]

Re: [Healeys] Changing the thermostat

To: awgertoo@aol.com, healeys@autox.team.net
Subject: Re: [Healeys] Changing the thermostat
From: Alan Seigrist <healey.nut@gmail.com>
Date: Sat, 16 Jan 2010 01:37:47 -0500
Michael -

Yes that's correct.  Make sure the thermostat gasket is very thin
paper and when bolting back on don't over tighten as you can warp the
housing, it is made from very soft cast aluminum.  Some hylomar or
silicone is a good idea.

Alan

On 1/16/10, awgertoo@aol.com <awgertoo@aol.com> wrote:
> I need to change the thermostat in my wife's BN7--it is pretty cold here in
>  MD and the car warms up very slowly and ultimately will not get over  140
> degrees--undoubtedly it is stuck open.
>
> I have a new 180 degree thermo and gasket.  Am I correct that all  I need
> to do is to drain the water level down to where it is below the level of
> the
> thermostat, pull the old thermo and gasket and replace them with  the new
> 180 degree one and the new gasket, bolt the thermo cover back on, refill
> the
> radiator and run?
>
> Best--Michael Oritt
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>

-- 
Sent from my mobile device

Alan

'52 A90
'53 BN1
'59 Jag Mk IX
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>