Are you sure of the wire color. There is 2 white wires. One is the
feed from the ignition switch the other goes to the fuel pump.
Then there are two white/ black wires, one goes to the distributor
points, the other goes to the battery cut off switch. You probably
have disconnected the white/black wire the goes to the batterey
switch. Look under the car and see if you have pinched the harness in
one of the harness clamps under the car. You also can disconnect the
white/black wire connector at the firewall behind the intake manifold
and try to start the car.
David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767
www.britishcarspecialists.com
.
.
On May 4, 2010, at 7:25 AM, Manuel Formosinho Sanchez wrote:
> I need help for the following: the ignition coil for my 1955 BN1
> has two white
> cables connected to one of the terminals and one to the other. Last
> Sunday I
> was driving the car and suddenly the engine stopped. No feed from
> ignition.
> After disconnecting one of the two white cables the engine
> restarted again and
> now is running with one cable disconnected and everything is
> working well.
> What is this cable for? Should I try to reconnect it?
>
> Thanks
>
> Manuel Sanchez
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/
> healeydoc@sbcglobal.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|