Greg -
That bracket is more or less useless. If the dash and tunnel are properly
configured and installed, you don't need that bracket, there will not be any
console movement.
Alan
'52 A90
'53 BN1
'59 Jag Mk IX
'64 BJ8
On Wed, May 19, 2010 at 9:19 AM, Greg Mandas <gmandas@yahoo.com> wrote:
> Thank you everyone who sent instructions. They were very helpful.
>
> The
> biggest help was in describing what SHOULD have been there. What WAS there
> was
> one lone screw holding the left side of the console to the dash. Next were
> the
> two screws holding the arm rest to the drive tunnel all the way in the
> back.
> In between every nut, screw and bracket is missing.
>
> Anyone have the bracket
> that mounts to the tunnel and secures the console, Moss part number NA?
> It's
> index number 143 on page 104 of the Spring 2010 Healey catalogue. Next
> best
> would be it's measurements.
>
> Greg
>
> 65 BJ8
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|