Rocker shaft nuts are 25 ft lbs. heat the old copper washers to max butane
torch heat, air cool, reinstall
frogeye@porterscustom.com
Porter Customs 2909 Arno NE
Albuquerque, NM USA 87107
505-352-1378
1954 BN2 1959 AN5
Porter Custom Bicycles
cars:
www.britishcarforum.com/portercustoms.html
gallery:
http://picasaweb.google.com/porterscustombicycles/PorterCustomBicyclesStuff
blog: http://porterbikes.com/
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of David Z
Sent: Thursday, May 27, 2010 3:59 PM
To: Healeys@autox.team.net
Subject: [Healeys] rocker shaft assembly
I purcased a replacement rocker shaft assembly for my BJ8 due a bit lower
than
normal oil pressure, oil in the rear air cleaner and squirting up from a
couple of the rocker arms. What is the suggested torque for the rocker arm
nuts? I know to be careful about applying too much torque to the oil supply
line. Can I re-use the copper washers on either side of the banjo fitting,
or
do I need to get new ones?
Thanks!
David Z.
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/frogeye@porterscustom.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|