healeys
[Top] [All Lists]

Re: [Healeys] Gearbox to engine dowel bolts position?

To: 'Bob Spidell' <bspidell@comcast.net>, Josef.Eckert@t-systems.com
Subject: Re: [Healeys] Gearbox to engine dowel bolts position?
From: Tadeusz Malkiewicz <tadeusz.malkiewicz@plusnet.pl>
Date: Wed, 04 Aug 2010 20:12:38 +0200
Hello Bob, Josef,

What end are you looking from?

When I look at the engine from the gearbox side, I have holes milled at 1 &
7 o'clock.

Best, tadek

-----Original Message-----
From: Bob Spidell [mailto:bspidell@comcast.net] 
Sent: Wednesday, August 04, 2010 5:22 PM
To: Josef.Eckert@t-systems.com
Cc: tadeusz.malkiewicz@plusnet.pl; Healeys@autox.team.net
Subject: Re: [Healeys] Gearbox to engine dowel bolts position?

On our BN2, there are milled recesses for bolt heads at the 1 and 7 
o'clock position--I figured the dowel bolts went there.

If not, why do only these two positions have milled recesses?

bs


Josef.Eckert@t-systems.com wrote:
> Hello Tadek,
> They go at 5 and 11 o clock position.
>
> Josef Eckert
> Konigswinter/Germany
>
> Betreff: [Healeys] Gearbox to engine dowel bolts position?
>
> Hello,
>
> There are 2 dowel bolts to mate the gearbox to the engine - where do they
> go??..
>
> Many thanks,
>
>   


-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell@comcast.net

*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>