healeys
[Top] [All Lists]

Re: [Healeys] carb oil

To: Richard Ewald <richard.ewald@gmail.com>, Michael Salter
Subject: Re: [Healeys] carb oil
From: Don Hardie <healeynut@yahoo.com.au>
Date: Wed, 11 Aug 2010 23:38:15 -0700 (PDT)
Just try driving without any oil in the dashpots and you will have a terrible
flat spot due to the pistons rising without any restriction and giving a weak
mixture. 

I recently was concerned about the pressure I had to exert on the
lift pins with 
20w50 engine oil, I removed it and replaced it with 3in1 oil
and a flat spot on 
acceleration, I then tried transmission oil, no flat spot
and gained about 2 
MPG.

Don 
OZ





________________________________
From:
Richard Ewald <richard.ewald@gmail.com>
To: Michael Salter
<msalter@precisionsportscar.com>
Cc: healey list <healeys@autox.team.net>
Sent: Thu, 12 August, 2010 12:26:50 PM
Subject: Re: [Healeys] carb oil

Yes
but does that higher flow rate more than offset the increased thickness
of the
needle due to the piston not rising?
Venturi vacuum is very weak, and I can't
see where even if the venturi
vacuum doubled it would overcome the lack of jet
area.

On Wed, Aug 11, 2010 at 7:20 PM, Michael Salter <
msalter@precisionsportscar.com> wrote:

> The rate of flow over the bridge
will be increased because of the
> higher vacuum created by the restriction of
the piston.
> Higher flow rate produces a larger drop in pressure at the jet
and the
> fuel flow is increased..
> All very simple really....    :)
>
>
Michael Salter
>
> On Wed, Aug 11, 2010 at 8:32 PM, Richard Ewald
<richard.ewald@gmail.com>
> wrote:
> > ::: Scratches head:::
> > The mixture
would be too rich if the piston rises too slowly?
> > The higher the piston,
the thinner the needle cross section at the top of
> > the jet.  The thinner
the needle cross section the more fuel can be drawn
> > out of the jet.
> > So
if too thick oil is used in the dash pots, the pistons will rise
> slower,
> >
This would leave a thicker cross section of needle at the top of the jet,
> >
and thus allow less fuel to be drawn into the engine.
> > Seems to me that
using too thick an oil would give a lean mixture on a
> snap
> > throttle
opening.
> > What am I missing?
> > Rick
> >
> >
> >
> > On Wed, Aug 11, 2010
at 3:44 PM, David Nock <healeydoc@sbcglobal.net>
> wrote:
> >
> >> If you use
a oil that you use is way to thick the piston will be slow
> >> to rise and
you will have a little to rich mixture when accelerating.
> >>
> >>
> >> David
Nock
> >>
> >
> >
> >> British Car Specialists
> >> Stockton Ca 95205
> >>
209-948-8767
> >>
> >> www.britishcarspecialists.com
> >
_______________________________________________
> > Healeys@autox.team.net
> >
Donate: http://www.team.net/donate.html
> > Suggested annual donation  $12.75
> > Archive: http://www.team.net/archive
> > Forums:
http://www.team.net/forums
> > Unsubscribe/Manage:
>
http://autox.team.net/mailman/options/healeys/msalter@precisionsportscar.com
_______________________________________________
Healeys@autox.team.net
Donate:
http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive:
http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/healeynut@yahoo.com.au
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>