healeys
[Top] [All Lists]

Re: [Healeys] BT7 door handles

To: "'Ron Fine'" <RonFineEsq@earthlink.net>, "'I Erbs'"
Subject: Re: [Healeys] BT7 door handles
From: "Rich Chrysler" <richchrysler@quickclic.net>
Date: Sat, 13 Nov 2010 13:06:51 -0500
I have had similar problems with these repro flat pull door handles. Closer
examination revealed poor finished castings with lumps and bumps in the
areas where the moving handle has to fit into the fixed portion of the
casting base. The manufacturers then chromed right over these bad surfaces.
I found that in some (but not all) cases some careful filing and relieving
of these casting problems in areas that don't show allowed the handle to fit
much better.

Rich Chrysler


-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Ron Fine
Sent: Saturday, November 13, 2010 12:09 PM
To: I Erbs; healey help
Subject: Re: [Healeys] BT7 door handles

I tried several reproduction door handles on my BN7 and they were all the 
wrong shape.  The tip of the handle stood away from the small rubber bumper.

I finally gave up on the reproductions and found some original ones that I 
had re-chromed.

Ron 
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>