healeys
[Top] [All Lists]

[Healeys] Re - Fuse block terminal A3

Subject: [Healeys] Re - Fuse block terminal A3
From: hypercubic at yahoo.co.uk (mike brooks)
Date: Sun, 10 Apr 2011 23:38:49 +0100 (BST)
John,

May not be relevant, but the earlier 100 BN2 diagram has the three
wires you 
mention plus the fourth is the supply to the fuel pump. Don't know
if this 
helps.....

Mike  Brooks
'56 BN2
Scotland

Date: Sat, 09 Apr 2011
21:13:10 -0700
From: john spaur <jmsdarch at sbcglobal.net>
Subject: [Healeys]
Fuse block terminal A3
To: healeys at autox.team.net
Message-ID:
<6.2.3.4.2.20110409210804.02064938 at pop.att.yahoo.com>
text/plain; charset="us-ascii"; format=flowed

1962 MKII BT7

My wiring
diagram shows three white wires attached to fuse block 
terminal A3. My wiring
harness has four white wires.

One goes to the overdrive relay, one goes to
the S.W. connector on 
the ignition coil and one goes to the overdrive switch.
The forth wire is in the wiring harness and follows the same route as 
the
wire that goes to the overdrive switch.

My original harness only had three
white wires.

What is the purpose of the forth wire?

Thank you,
John Spaur
 
Reply to: mike.brooks at alumni.warwick.ac.uk 

<Prev in Thread] Current Thread [Next in Thread>