healeys
[Top] [All Lists]

[Healeys] Pressure relief valve

Subject: [Healeys] Pressure relief valve
From: bspidell at comcast.net (Bob Spidell)
Date: Sat, 30 Apr 2011 19:16:36 -0700
Background: my BJ8 has run low oil pressure at idle for as long as I've had it. 
At startup I get 60psi, but after 
running on hot days I would register, for all intents and purposes, zero psi at 
idle. In spite of this, the engine has 
run and performed well for me for over 100K miles. I use 20W-50 dino oil.

There has been a lot of discussion on the BCF about replacement relief valve 
springs being shorter than spec.  It has 
been suggested that putting washers or other shims or a 1/4-inch bolt behind 
the spring could increase running 
pressure.  I actually didn't believe it because AFAIK the valve is there to 
keep pressure from getting too high, and 
presumably would be fully closed at normal running pressure.  But, I was 
curious ...

So today I pulled the relief valve and measured the spring at 2 & 11/32"; quite 
a bit less than 'spec.' So I installed 
the 1/4-inch bolt and fired her up; 70psi on cold start/fast idle--not too 
surprising. What's surprising is even after 
the engine has warmed-up--when I would normally see 10-20psi, before a long run 
in hot weather--I am getting 40psi. And 
the max pressure is still at 70psi; so the effect is max pressure is up 10psi, 
but the hot idle pressure could be up 
10-20psi!

My questions to the forum are: is 70psi too high a max oil pressure? Any 
explanations for this phenomenon? Should I 
split the difference with some shims?  Go back to the spring-only setup so I 
can sleep?

Bob

-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell at comcast.net

*******************************************************************

<Prev in Thread] Current Thread [Next in Thread>