After the fine folks at Cape International shipped me the updated bracket,
gratis, I was able to hook up the carb end of the cable. The next step was
how to attach the throttle arm end. I fabricated an easier to attach bracket
to attach the throttle arm end of the cable. At this point, not beautiful,
but it is proof of concept. Not sure about how much throw I have on the carb
shafts, but I hope to know asap. Need to wire up my dash and insulate any
bare wire ends from things not hooked up yet, hang my exhaust and see if I
can light her off and not burn up the loom.
Stay tuned....
|