I'm an engineer and I can do a drawing of the setup, once I go through the
process. The only machining needed is on the spinner and this needs to be
coordinated with the balancing machine. I'll use Hunter balancers, since
they're the most popular manufacturer.
From: Michael MacLean [mailto:rrengineer.mike at att.net]
Sent: Monday, February 27, 2012 2:52 PM
To: Healeys at autox.team.net; Ed O'Neal
Subject: Re: [Healeys] tire balance
Yes, I would like this set up to. Anyone have the dimensions ot is there a
drawing, article, etc. for this set up?
--- On Mon, 2/27/12, Ed O'Neal
<ed at wadsworth-eng.com<mailto:ed at wadsworth-eng.com>> wrote:
From: Ed O'Neal <ed at wadsworth-eng.com<mailto:ed at wadsworth-eng.com>>
Subject: [Healeys] tire balance
To: "Healeys at autox.team.net<mailto:Healeys at autox.team.net>"
<Healeys at autox.team.net<mailto:Healeys at autox.team.net>>
Date: Monday, February 27, 2012, 7:08 PM
Does anyone sell wire wheel balancing set-ups - hub + spinner with machined
If not I need to locate a used left rear hub (with good splines) and a used
left side spinner to have machined locally.
Suggested annual donation $12.75
Healeys at autox.team.net</mc/compose?to=Healeys at autox.team.net>
http://autox.team.net/mailman/options/healeys/rrengineer.mike at att.net