Re: [Healeys] fitting piston/caliper seals

[john spaur <jmsdarch@sbcglobal.net>]

I fit them to the bottom of piston then fit them to the caliper and 
push the piston into the bore if I recall correctly.
John

At 06:06 PM 4/26/2012 +0100, Simon Lachlan wrote:
> Hi,
>
> Can someone kindly remind me of the proper/easiest way to fit the seals into
> my MkII BT7's callipers? I'm referring to the rubber boot things that go
> into the outer groove within the bore and the groove around the top of the
> piston.
>
> Likewise, don't I recall that the inner seal was slightly tapered? My new
> ones are square in cross section.
>
> Simon
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net