healeys
[Top] [All Lists]

[Healeys] Fwd: Moss Motors adjustable camber bushing set

To: healeys@autox.team.net
Subject: [Healeys] Fwd: Moss Motors adjustable camber bushing set
From: warthodson@aol.com
Date: Wed, 5 Dec 2012 09:05:43 -0500 (EST)
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <8CFA06ECD9E2296-9BC-51AF@webmail-d044.sysops.aol.com> <CAKAwfjceXxuGorgDYeFbGZjLrvZKbpJvQcygeHe6gCqmiK6Nsg@mail.gmail.com> <8CFA108A8E017FA-1980-903B@webmail-m011.sysops.aol.com>
Chris,
I understand your explanation concerning shortening the shock arm length, but
that is not the effect when the bush is installed with the hole "closer to the
engine". The hole is never closer to or farther away from the engine. The
hole, regardless of where it is orientated, is always the same distance from
the engine because it is located by the fulcrum pin which is in a fixed
location determined by the shock arms. When the bushing is orientated as shown
in Moss Motors left illustration, it is the fulcrum & therefore the top of the
king pin which is located farther away (not closer) to the engine resulting in
more positive camber, not less camber.
Gary Hodson


-----Original Message-----
From: Chris Dimmock [Healey] <austin.healey@gmail.com>
To: warthodson <warthodson@aol.com>
Sent: Wed, Dec 5, 2012 12:19 am
Subject: Re: [Healeys] Moss Motors adjustable camber bushing set


Gary
The diagram is correct.
Think of the bushing as either shortening or lenthening the shock arm.
A shorter shock arm reduces camber. A longer shock arm increases it.
e.g. if you had 1 degree positive camber, and shortened the shock arm, you
would end up with less than one degree positive camber.
i.e. if the hole is closer to the engine you are shortening the distance (in
compriion to a standard bush) and reducing positive camber.
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


<Prev in Thread] Current Thread [Next in Thread>