Stock bt7 tach is mechanical
Ground wire needs to rest on unpainted shroud area
i removed my overdrive electronics when I installed my smitty kit.
Ira Erbs
IT Consultant.
Portland, OR
On Dec 27, 2012 7:34 PM, "john spaur" <jmsdarch@sbcglobal.net> wrote:
> 1. Does it matter if the black ground connections are attached to the
> shroud or the steel frame (rear lighting harness near the signal lamps)?
> 2. Does it matter which wire from the overdrive solenoid connects to the
> terminal on the gear box switch?
> 3. If so, which terminal does it connect too?
> 4. Is the BT7 tachometer mechanical? I would like to know if anything
> needs to be changed internally should I decide to switch to positive ground.
>
> TIA
>
> John Spaur
> San Jose, CA
> '62 BT7
> ______________________________**_________________
> Support Team.Net
> http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/**listinfo/healeys<http://autox.team.net/mailman/listinfo/healeys>
>
> Unsubscribe/Manage: http://autox.team.net/mailman/**
> options/healeys/eyera3000@**gmail.com<http://autox.team.net/mailman/options/healeys/eyera3000@gmail.com>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|