by any chance have you installed a BJ8 brake master as your clutch master
by mistake? They look the same but are smaller diameter.
On Fri, Jan 4, 2013 at 11:52 AM, john spaur <jmsdarch@sbcglobal.net> wrote:
> My apologies if this message is received more than once; it seems to have
> been lost on the Internet several times but my test was not.
> ______________________________**___
>
> I installed a lightened Denis Welch flywheel and throw-out bearing along
> with BJ8 clutch disk and housing which is all supposed to work together.
> However there are some issues I don't understand.
>
> The first motion shaft will rotate in neutral which I think is normal.
>
> When I depress the clutch pedal (it is bleed properly) I can engage the
> transmission in first or second gear only when the pedal is about 1/2 way
> through its travel. If I floor the clutch pedal the first motion shaft
> starts to turn and I cannot shift into gear without grinding
>
> I cannot shift into reverse or third and forth. I could when the
> transmission was on the bench and ready to reinstall.
>
> Any ideas of what I should trouble shoot?
>
> TIA,
> John Spaur
> '62 BT7
> ______________________________**_________________
> Support Team.Net
> http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/**listinfo/healeys<http://autox.team.net/mailman/listinfo/healeys>
>
> Unsubscribe/Manage: http://autox.team.net/mailman/**
> options/healeys/healey.nut@**gmail.com<http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|