Trying to redo the padded dash top, There is a little metal angle bracket
that attaches (via split rivets) to the plywood on each end. Which way do
they go? Mine the brackets were attached with the flange on top of the
plywood with the split rivet head on the metal going through the plywood with
the tangs bent underneath. Yet a photo in the Heritage Upholstery web site
shows the bracket attached under the plywood? Which is correct?
I do not know is mine was redone ever, but the plywood is shot and we made a
new piece.
Also what actually attaches the dash pad to the car. I seem as only the two
screws the hold the rear-view mirror down hold it in place. It has been so
long since the car was assembled that I am not sure anymore. Does the front
of the pad get captured by the bottom of the windshield frame? I am not to
that point yet.
Thanks
Jeff
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|